:-/

Ummmm.......ok, maybe I'm not looking in the right places, but how do I scale a pic up or down in PDF? I'm feeling very dumb right about now......HELP!!!!


[glow=red,2,300]Thanks![/glow]. ;D

Hawk,

I could be wrong here but I think the only way to rescale your models is from within your advanced printer properties. This largely depends on what brand of printer you use and what your drivers are like. If you have an Epson printer follow these steps:

1. Select "File", "Print", "Properties", "Layout".
2. Check the "Reduce/Enlarge" box
3. Check the "Custom"  selection. You can then input what scale you would like to print your models at. This depends on what scale your miniatures are and what you’re shooting for.

"MOST" printers have an option to reduce and enlarge prints so the option should be in your "properties" or advanced properties dialog. The reason it wasn’t explained in the manual is that every printer has its own way of handling this function. It would be impossible to explain this procedure for all printer models. If you can’t find this function on your printer refer to your printers manual or homepage for tech support.

If you are reducing your models due to improper tab settings on your printer (Pages being cut off) see the following topic: http://www.worldworksgames.com/forum/viewtopic.php?t=14

If anyone has any other helpful information for Hawkwolf please give us a hand. I could be missing something far simpler. Can you do this from within "Reader"??? I hope the above info helps Hawk. I’m off to bed for a few. Take care!

:-[

Thanks for trying anyway.....I was just wondering if it was a function of the printer or if I could resize in the Adobe Reader.

I have a Lexmark Z32, but I can't seem to find anything about sizing...... DOH!

Oh! Denny, did you see I made a cylindrical tower from your square one?  ;D

Sorry, I didn't reply to your earlier question. I'm not having a problem with cropping or anything like that, I just want a smaller castle! (Yeah, like anybody would want that!!)  ;D