Did I miss somewhere a message regarding the print instructions for the components that form the bottom of the roll arena product?


I didn't notice it at the time, but the parts for the bottom of the drawer area don't match to the parts for the rolling surface itself. It's just slightly smaller. I thought there might be some kind of mistake so I checked the fit of the corners to the bottom half's floor and they fit properly. I also checked all the pages in the area.pdf as well as the arena instructions.pdf and didn't notice anywhere that it says to "print at 110%" or something to that effect.

That sound like either a printer error, a possible build error. My build matched more or less fine other than a few bad scores.

Well the fact that I hadn't seen any comments about it is why I asked.

I'm going to try reprinting those pages for the bottom section and see if I get different results.

It was print settings.

I had them printed up at FedexKinkos and the first time they printed it for me at the counter. The second time I printed from flash drive to the machine directly. Evidently, they're machines will automatically print as 'fit to page' instead of printing normal.

Haven't finished it just yet... ADD kicks in a bit. Hope to finish it up this week... however so far... enh... I've got extremely mixed feelings. EDIT: Overall, I'd say that I love the concept and think it's a great idea, and I like it better than the dice tower ideas that most (including WWG) companies produce. It's the execution of the idea that leaves me wanting.