Solution has been to actaully cut the upper surface of the foamcore then 'steam' the smaller areas, each has flattened out more and teh cuts have been done where the walls will go.

The building has much from Worldworks construction used but is actaully own design with own textures, but will be populated by worldworks furniture.

If this works out I may put all the graphics together to form a pack for what will be a 2ft x 1ft mansion (in area) with 2 floors, walls totalling 7 inchs.

I was unable to find the glue that has been suggested, and with the nearest office store being over an hours drive from here I went for what I could find which has been the 'Power Pritt Gel, spread in very very thin layers.

I have a suspicion that the method I used to smooth the card onto the board might have stretched the card as I have no problems with the walls(which for the outer walls is being glued onto 1/8th" heavy mounting board)

Am enjoying these little builds.

Camera borrowed, check Gallery..

Just a quick tip for all the other lazy bums out there...

Here's where you can see all the latest additions to the WWG image galleries:

http://wwgallery.pcinfoman.com/thumbnai ... stup&cat=0

(Or from anywhere within the gallery, click on "Home", then "Last Uploads")


I regularly keep track of this page to see if anyone has added something new. In fact, I often catch pictures the owner hasn't even announced on the boards yet.


(Along similar lines... I *always* use the "" link from the main WorldWorksGames Forum page to keep track of the latest developments here. So much easier than browsing through all the forums individually...)

Some good ideas there, big thanks, will see how some look, think will look good to have different rooms with different interior decoration

I got one part for VIP guest, another for 'staff', then the primary living area and the 'offical' rooms

Started the 2nd half the of lower floor...

Have devided wil nt get a 2nd floor afterall, willbe plenty good enough with just the one.

Have also started to put some interior peices in, mostly from the inns and dungeonworks pack (actaully a bed and fireplace so far, the rest still on the card uncut!)

Have changed the method of construction for the 2nd half, am doing all the walls first to give it vertical strength and thus when I put the floors in it should reduce the ability for the foamcore to wrap as its got to fight against the walls

Oh yes almost forgot a link..