Spray Adhesive!


I mount my floor tiles on foamcore (and do each tile individually, putting velcro on the bottoms, and matching velcro on a 21"x35' board so that I can create a variety of different masterboard configurations quickly and easily). Spray adhesive is GREAT stuff for doing this easily, I've discovered. Print the tile, cut it, spray the board, mount it, done. While I do my tiles individually, I would imagine it would work building a masterboard.

Just do it outside. The adhesive can be nasty.

To clarify, this was building my floor tiles from the Chunky Dungeon module.  

I would trim all of the excess on the page, then apply the page as a whole, making the most out of my foamboard, then cut the floor tiles out.  Basically I applied all of them at once to the board then came back and cut them all out at once.

The only steps different from the instructions within the module was that I used sticker paper instead of 110pd and glue.

Thanks for the responses, it has given me some ideas and food for thought!