You shouldn't be having too much trouble, Mags, just make sure your adobe reader is set as per the WWG guide and all should be kosher.

As for the job, it's hardly top-secret. I'm creating an add-on set for Mayhem, it's a matter of public record. As to the nature of that set, you'll simply have to wait. I can only say all is proceeding under the watchful eye of the master and is moving forward at a reasonable pace. I will NOT be dropping hints or speculating on release dates. This is my first run out of the stable and I'm not looking to hand out rope (how's that for mixing your metaphors?).

Hey, if you want to see some work that you can do with Dundjinni, check out this link from my site, .

Click on the link The Shrine of Janna - Part 2. Then on that page, look at the GMs comments, I have links to some pictures I took of that adventure. The maps on the foam core of the tower are all created with Dundjinni. I converted them from another map that I found on the internet, each one took me about 30 minutes to complete in the program. Then another 10 minutes more or less to cut out and mount.

Skunk

Check out my fantasy campaign, Wizard Quest, a world using Wizards of the Coast’s 3.5 DnD system by visiting .

Check out what games I’m working on and their status by visiting .

I’ve created a page on my site to post funny quotes from my players. Visit to read them.

I know about not having enough life, I don't have time to do half of what I want.

The print outs have a 3D look to them due to shading provided by the program itself. I need to take some time to get some closeups of the tower itself and then post them so that people can see what kind of results you can get with Dundjinni.

The without sails is mostly because I haven't finished her yet. That problem with not enough time. Anyway, I'm going to eventually get the last mast done and then put on the rigging, but not sure about using the sails. From just the little bit I've looked into as far as adding them, I think I'll have trouble with moving figs and having the sails around.

I hope to spend the rest of the time finishing her in the next 2 weeks. Course, I didn't have any transparency paper till just last week, so I couldn't do the rigging anyway.

I was originally going to build the tower in 3D, the first level is semi finished, but didn't really have time to do it right, so I gave up and went with the 2D maps instead. Plus, I really didn't want to spend a lot of time on something that would be used only 1 time.

Course, I could always develope a con scenario out of it. Hmmm, ideas, ideas, ideas.

Skunk

Check out my fantasy campaign, Wizard Quest, a world using Wizards of the Coast’s 3.5 DnD system by visiting .

Check out what games I’m working on and their status by visiting .

I’ve created a page on my site to post funny quotes from my players. Visit to read them.

Hey magsman, got off my lazy backside, actually, just to a few minutes out of my otherwise busy schedule to snap some close up picts of the Dundjinni maps. I only pulled out 4 of the 6 maps, but they give you an idea of the quality that you can get from Dundjinni, with spending just a little time on it.

To look at them, go .

[Edit]Oh, forgot to mention, click on the Shrine of Janna link![/Edit]

The middle of each level might be a little washed out from the flash, but I wanted to get them up so that you could look them over.

Skunk

Check out my fantasy campaign, Wizard Quest, a world using Wizards of the Coast’s 3.5 DnD system by visiting .

Check out what games I’m working on and their status by visiting .

I’ve created a page on my site to post funny quotes from my players. Visit to read them.