Ok, one of my sets if Villageworks. I was going to make some buildings for Warmachine. Not sure if they would just be obstacles or have interiors. As I think about it, maybe get Pubs & Inns Interiorworks to flesh out the interior but I also wanted to use 5mm foam for strength. Would it be best for me to just make the walls/buildings from Interiorworks? I saw the sticky about mirroring the walls in Villageworks to make them doublesided which I should be able to do.

Instead of a folding the walls together I can just cut the sides apart and paste one on each side of the foam. I figured I would angle cut the ends to be 45 degree so that two walls can join together more easily.

What about the roof? Would the rooks with the Villageworks be good? Would I have to enlarge them or anything since I added foam to the walls? I saw there was a kitbash for adding corner supports for upper floors. Perhaps that would be useful.

Thanks for any tips. I have made a couple of the villageworks buildings without foam and they are nice. Just wanted to give them more...strength for when I start putting figures on top of buildings...Warjacks can be heavy.

While this post shows modern buildings, the techniques for doing this for Village works would be the same:

http://www.worldworksgames.com/forum/vi ... php?t=5028

If you cut your foam core to the size of the external walls, the roof will still fit fine, as the overall dimensions are the same. You will have to trim the mirrored interior walls to fit.