One side printed out smaller than the other. Is this normal?
Honestly, If this were my first impression i would not have bought the castleworks, dungeon works and the ship too. But since those are all great,
I'm guessing it's a glitch, is there any way of fixing it?

Hi Blacksmith,

First off, welcome to the forums and thanks for your support.

I just printed the Bone Bridge and didn't notice any problems with it. I think there must have been something wrong with the print properties in Acrobat: having any sort of scaling turned on will really mess things up with the models.

Try printing it again, and pay particular attention to the page scaling settings. Your printer properties may allow scaling (and mirroring and whatnot) so you might have to check there as well.

Hope that helps.

D