It feels like things move very slowly, when you can only work on them in one hour chunks...
Tonight, I printed out some of the railing walls, and I made a sheet of 1" three-way posts. On the sheet, I also included full-height 3-way posts, where one of the connectors on each was low enough for a 1" wall. Here are some new pictures:
Not too shabby for a first print! The low posts came out nice, and the railings looks right at home. It's funny, I had to use more dwarven walls since I still don't have any *regular* Himmelveil walls or posts! Anyway, you can see in the back there's a low wall attached to a post with a regular wall. I think I want to tweak the post so that it has a tab at the top as well as the bottom to hold it's shape. Right now, it's got a tiny tab at the bottom holding it together, which is OK, but the top opens up a little too much.
I was going to attach the 1" wall to the rounded tile I did, but I don't have the extra anchors done, and I'm not sure if I want to just attach regular anchors and have them hang over the curved edge a bit, or if I want to make custom anchors for the tiles. I need to make another sheet of anchors for the streets tiles anyway - I have a lot of tiles without anchors. Understand, though, that I had a marathon anchor making streak. I cut, glued and edged six or seven sheets of anchors in order to retrofit all of my Hinterland and Himmelveil tiles, as well as to add anchors to some miscellaneous tiles that have been kicking around unfinished. I've still got more anchors to do, but I don't want to go insane.
I'm going to go back to finishing more Hinterland Cliffs stuff for now, but here's a quick list of things I hope to get done for this curved walls endeavor complete.
Tiles
» 6" half-circle (done)
» 6" half-circle with 6"x3" extension (done)
3" quarter-circle
Not sure if I can pull off the inverse of the 3" quarter-circle...
Posts
1" high 2-way posts
» 1" high 3-way posts (done)
1" high 4-way posts
2" high 2-way post variants for 1" connections
» 2" high 3-way post variants for 1" connections (done)
2" high 2-way post variants for 1" connections
Walls
» 2" high curved HV Streets walls (done)
» 1" high curved HV Streets walls (done)
» 1" high curved HV Streets railing walls (done)
» 1" high 3" HV Streets walls (done)
» 1" high 6" HV Streets walls (done)
1" high 3" HV Streets railing walls
1" high 6" HV Streets railing walls
And cutter files for them all... it's been a long time since I had to cut posts by hand, and while it's not bad making a couple, if I'm going to be doing a full set of these, I want by robo cutter to do the work!
|
