So here I was this evening, assembling tiles for a PCON build and I noticed something...

The slime tiles are not perfectly square. One length is 7" while the other side is 6 15/16". This is having the effect of throwing the squares off.

In order to verify that this is not because my cheap ol' printer is not screwing up on me (again) can someone verify my findings?

Thanks.

EDIT: I did verify that scaling was disabled and I printed 3 copies of the same tile seperately each on eexhibited the effect.

Thanks Denny. I do hope that it is on my side because then I can complain to my wife-fu that I need a new printer

I dunno what to tell you, pelthar. I just double checked all the masters and they're exactly 7.01" square (the extra is a bit of keyline). The only exception is the X-intersection and that's 7.01"x7.025" for some odd reason but nothing on the scale you're mentioning. I'm stumped.

I printed out the tiles on a Cannon iP4000 and they seem to be matching up and working. Could it be Adobe or something?

Oh, I'm the Smiter of Those Who Think Ellipses (...) Should Be Used Every Other Sentence. I prefer not to be a Spelling Nazi, but apparently I belong to the Grammar Allgemeine-SS.

Busted!

To redeem myself: ellipses is the plural of ellipsis, and the pronunciation can be found .