Several of the sets are only 1 inch grid format. Is there a way to make them 1.5 without screwing up the build.
LMK
| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| 1 inch to 1.5 http://www.worldworksgames.com/forum/viewtopic.php?f=3&t=7330 |
Page 1 of 1 |
| Author: | scarden [ 06-04-2009, 07:37 PM ] |
| Post subject: | 1 inch to 1.5 |
Several of the sets are only 1 inch grid format. Is there a way to make them 1.5 without screwing up the build. LMK
|
|
| Author: | CapnG [ 06-04-2009, 08:02 PM ] |
| Post subject: | |
If your printer supports it, print our floor tiles at 150%. |
|
| Author: | scarden [ 06-04-2009, 08:12 PM ] |
| Post subject: | |
I will try that I want to get the new Undercrypt set for pathfinder but use Mage Knight clix figs. Thanks for the info
|
|
| Author: | CapnG [ 06-04-2009, 08:33 PM ] |
| Post subject: | |
A word of warning: this technique will require you to some manual kitbashing of sorts, as obviously the original set was made to match specifically to 1" format. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|