I made a few errors in building this, but nothing which is immediately obvious (I hope). I went for a permanent build.


Dice1.jpg [ 162.24 KiB | Viewed 8536 times ]



Dice.jpg [ 120.56 KiB | Viewed 8536 times ]


Now, someone go and kitbash the dicetower to other textures already!

Looks good. But where are the dice?

Great! How stable is it?

It's OK. The dicetower is glued to the rooftop, but the rooftop itself would benefit from an additional layer of cardboard. If you pick the whole thing up (or throw the dice), the dicetower sways a little. Not that bad, but noticeable.

The interior brace for the Swiftscenic building itself works fine, but again, I'd strengthen the walls with something extra if I were to build another one.

That was fast Zorg. Looks great and thank you for sharing!

Belated acknowledgment: Nice build

Any dice towers I've done have been built on foamcore for everything accept the lower dice tray and the actual top. I've found that the foamcore makes everything very stable!

Though after my first one, every other one I've built, the opening where the dice exit is slightly above the dice tray as with my first one, the dice have a tendency to roll back into the opening!

Thanks, guys. I find dice towers to be really useful; there always someone who throws the dice through all the minis, on the floor, and in the coffee.