I figured I would log my progress building out my set of ships, TOSs and Game Aids for Wormhole. I'm a bit of scatter brain, so I need to be methodical about the entire process or I'll end up printing extra pieces; like the Maiden extras in the bottom drawer of my desk.

If you are building both sides (Blue & Orange), you will print the following for both.

SHIPS (Number to print)
1 Hammer Head (Hammerheadblue.pdf X 1)
1 Carrier (carrierblue.pdf X 1)
3 Control Corvettes (controlblue.pdf X 1)
4 Particle Bows (particleblue.pdf)
3 Missile Fighters (missileblue.pdf X 1)
4 Skirmish Fighters (skirmblue.pdf X 1)

UPDATE 5/29/08: You only need to print 1 copy of page 2 from controlblue.pdf OR particleblue.pdf; you will end up with 10 stands which are identical for the Control Corvettes and Particle Bows

UPDATE 5/30/08: The Automated Defense Platform uses the same stand mentioned in the above update.

TRAYS (Number to print)
1 Command Tray (commandtray.pdf X 1)
1 Fighter Tray (fightertray.pdf X 1)

TOSs (Number to print)
1 Hammer Head TOS tray (hammerhead.pdf X 1)
1 Carrier 1 TOS tray (Carrier.pdf X 1)
3 Control Corvette TOS trays (control.pdf X 3)
4 Particle Bow TOS trays (Particlebow.pdf X 4)
3 Missile Fighter TOS trays (missile.pdf X 3)
4 Skirmish Fighter TOS trays (skirmish.pdf X 4)

The TOSs may vary depending on your needs, but the above amount will cover all the ships built.

This may seem a bit elementary, but that's what I need to do!

I'll update this post once I move onto the Game Aids.

Feel free to pitch in

One thing to note is the Particle Bow and Control Corvette look to share the same stand-riser, and there's a ton of them in each PDF. I didn't realize this until after I printed, and thought "Hey, I coulda just printed that page once to get enough risers for both ships..."

Thanks for pointing that out. I updated the post.

that riser is also used for the ADP (automated defense platform)

Hmmfff. I wish I had planned my printing out as thoroughly.

I'm pretty sure I'm going to end up with a lot of surplus risers for the ParticleBow/ControlCorvette/ADP.

Oh well, extras for later.

That kind of organization is a good idea. I'm gonna do likewise...

Darn, i just printed one of every PDF in blue, and now realize I have lots of extra parts. Props to you for better organization.

--Rick--

Thanks for pointing that out

Updated the original post.

Kind of a related question—how many sheets of black foamcore (assuming 20"x30") are required for a starter build? I know I need four for the Uncharted Space board, but how many do I need for each player's Trays, ship bases, etc?

Thanks!