This is definately not intended as a criticism, simply a request for a minor improvement to what is already a wonderful product.

Looking over the Villageworks buildings, and the Small buildings in particular, it seems to me that the roof pieces could as easily be done as a single piece, rather than two separate ones with a tab down the middle.  Put them together on the page, and slant the whole thing slightly to one side, and it'll fit nicely on the page even still, but require less cutting, less gluing, etc.  

If you could look for other little ways to "use" the pages to their maximum potential like this, I'd be genuinely and deeply appreciative.  

Hmmm...I'll have to look at the pages again. I do my best to optimize object placement on page with every prop. The issue with VillageWorks was making the set universally compatible with various printers and as such I had margin issues to contend with (I couldn’t exceed certain boundaries on the page).

With that said....With so many items in each set sometimes I get side tracked and miss obvious orientation solutions while obsessing over other issues. I'll do my best to keep on top of it.