During beta testing of this, I had an issue with the Studio file for the Motorbike models.
It cut well, and was really accurate, but , with no control over the perforation widths, the fold perforations were not working very well.
In fact some were tearing and breaking apart even whilst removing them from the sheet.
For consistency reasons the Studio file was used in the release set...but I made my own .gsd file to test build these bikes, they are great little models, and the machine cut really helps with them.
I was asked if I would like to share it with the community after the set was released..so here it is folks
There is a .gsd and a .studio file in there, the .studio may work with some setups, we didnt get the chance to get proper feedback on that one