| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| Silhoutte SD Arrives http://www.worldworksgames.com/forum/viewtopic.php?f=62&t=10765 |
Page 1 of 1 |
| Author: | Talae [ 01-13-2012, 04:10 PM ] | |||
| Post subject: | Silhoutte SD Arrives | |||
I am very excited to say that my Silhouette SD arrived today. I just unboxed it and decided to post some pictures before setting it up. Any advice would be wonderful.
|
||||
| Author: | Squirmydad [ 01-13-2012, 06:35 PM ] |
| Post subject: | Re: Silhoutte SD Arrives |
Cool. 1) Take the backing sheet that comes with the SD and either wash it to reduce it's tackiness or tuck it away on a shelf and forget about it. 2) Go find the both the latest version of the Studio drivers and the last version of the Robo-Master drivers. 3) Cut out some simple things that didn't use much ink and you don't care a lot about first to check how well your printer is doing and whether your cutters alignment is correct. 4) I'm really serious about #1. Congratulations! 
|
|
| Author: | Talae [ 01-13-2012, 06:52 PM ] |
| Post subject: | Re: Silhoutte SD Arrives |
I didn't read the above until too late and forgot about it from when I read it long ago. I should have been thinking ahead and purchased some adhesive spray. I will pick some up this weekend. So far, so good. First sheet was way too tacky and bent the pages quite a bit, even with me being cautious when removing the page. I removed some of the tackiness and the second sheet went great. The third sheet (first hallway I tried to cut) was off by 1/8" inch horizontally. I tried a fourth and it is off too, but this time it is off by a half inch in spots. I think something is happening mid-cut to knock the blade off track. Thoughts? Edit: Cut another one and it was only marginally off. I think it might be a user error on my part related to placement on the cutting mat. Is that likely or do the registration marks correct placement of the paper on the cutting sheet? I am limited to no more cutting tonight due to the noise level and my daughter being asleep. I will try again in the morning. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|