(Note: I'm reposting this from the Genet Models workbench because it might be of interest here as well.)
One of the other problems I needed to solve was a hardware compatibility issue with the Silhouette Cameo cutter, which uses a different registration mark setup than the Silhouette SD and Craft ROBO machines that preceded it, and it has trouble dealing with the older registration mark setup.
I solved that on my end by creating a separate set of PDFs for the Cameo, but that doesn't help customers who already have a stack of printouts with the old registration marks, and I sure as heck am not going to spend the next several weeks tediously re-stamping 10 years worth of stuff. So, it had to be something that would work with existing printouts and not require me to go back and redo a mountain of old PDFs.
The basic idea is there's a sheet of new Cameo square regmarks for the bottom left corner. You slit them out and stick them over the old Silhouette SD/Craft ROBO regmark, and shazam, Bob's your uncle. Well, that's the theory anyway.
I've been wanting to do this for a while, but since I don't have a Cameo and I had no luck the last time I tried to find a Cameo user on the WWG forum, this ended up on the back burner until today, when a Cameo user finally got in touch with me.
BUT THAT'S NOT ALL!
In theory again, this should be compatible with everyone's models, not just my own. The reason I think that's the case is because the size of that one square Cameo regmark seems to remain constant regardless of how large the other regmarks are. So, it should also work for models from WWG, Fat Dragon Games, and anyone else who has been doing GSD or Studio files for their models.
Grab it here:
Let me know if it works.