| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| Money is not an issue...what cutter to get? http://www.worldworksgames.com/forum/viewtopic.php?f=62&t=11945 |
Page 1 of 1 |
| Author: | Lormax [ 12-27-2012, 03:32 AM ] |
| Post subject: | Money is not an issue...what cutter to get? |
Cutting this stuff out sucks. Just finished a Maiden build. If I can get a machine to do all the cutting for me, awesome! What's the best machine out there to get? Like the topic says, money isn't really an issue at this point. |
|
| Author: | oldschooldm [ 12-27-2012, 09:54 AM ] |
| Post subject: | Re: Money is not an issue...what cutter to get? |
Well - there is a lot of user-generated cutfile support for the Silhouette line - Any one of those will do nicely if you plan on cutting out a LOT of stuff... I don't know I'd buy anything different, even if I had lots of money. |
|
| Author: | Lormax [ 12-27-2012, 08:10 PM ] |
| Post subject: | Re: Money is not an issue...what cutter to get? |
Is there a big difference between the Silhouette Cameo and the SD? I know the Cameo is the current model, but if there's issues, I'll try to find myself an SD. |
|
| Author: | ehisey [ 12-30-2012, 12:17 PM ] |
| Post subject: | Re: Money is not an issue...what cutter to get? |
I think the Cameo is well supported now. If you really have unlimited budget, you might want to also look at something to cut the foamcore also. I know on the forum there was a fellow that worked in a framing shop so had access to a large cutter that handled both mat board and foamcore. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|