| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| Problems with Thoumont's TLX and Cameo http://www.worldworksgames.com/forum/viewtopic.php?f=62&t=12301 |
Page 1 of 1 |
| Author: | johndoc [ 08-01-2013, 05:38 PM ] |
| Post subject: | Problems with Thoumont's TLX and Cameo |
I decided to start with thoumont's and printed out a wall. I used the method of combining the .psd for the cameo registration marks layed on top of the pdf, which worked beautifully on the roll arena, and it cut in a very odd fasion on my cameo. Half an inch away on one side, perfect on another, and imcomplete on the bottom. Any ideas on what I did wrong? |
|
| Author: | Ninevah [ 08-03-2013, 09:56 AM ] |
| Post subject: | Re: Problems with Thoumont's TLX and Cameo |
I don't have the Cameo, I have the Silhouette SD, but I assume that it works about the same. Are you sure you fed the page with the BOTTOM EDGE in first? If not, then it'll likely be a bit off, but still kinda look like the right shape and all. I've also had my cutter rollers slip once or twice and get the whole page off by an inch or two. It made a goofy sound when it slipped, so I knew something odd happened. Is it possible it was just a one-time fluke? |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|