| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| Blade Settings Help http://www.worldworksgames.com/forum/viewtopic.php?f=62&t=12411 |
Page 1 of 1 |
| Author: | Roscoenator [ 10-23-2013, 12:29 AM ] |
| Post subject: | Blade Settings Help |
I am sure this can be found somewhere but I can not seem to find it myself. Does anyone have blade settings for the newer numbered blade? Every setting I try either does not cut through the paper or seems to snag and cause my cutter to grind and then miss-cut everything after that. I am cutting 110# generic cardstock on homemade carrier sheets of the same cardstock. Any tips are appreciated. |
|
| Author: | mproteau [ 10-23-2013, 02:28 AM ] |
| Post subject: | Re: Blade Settings Help |
I set my blade to 3, and I usually do a double-cut. I cut at max speed and max pressure. One thing to make sure is that your carrier sheet is tacky enough to hold the page well. |
|
| Author: | oldschooldm [ 10-23-2013, 06:35 AM ] |
| Post subject: | Re: Blade Settings Help |
| Author: | mproteau [ 10-23-2013, 06:52 AM ] |
| Post subject: | Re: Blade Settings Help |
| Author: | Rzasa [ 10-23-2013, 01:04 PM ] |
| Post subject: | Re: Blade Settings Help |
This bothered me for awhile too, I had an awful time getting it to work. I had mine on 5, dropped it to 4 because it was scoring the carrier sheet a little too deep. Make sure you set the setting in Silhouette Studio to Cardstock, that fixes just about everything. ~J |
|
| Author: | Haydn [ 10-28-2013, 01:03 AM ] |
| Post subject: | Re: Blade Settings Help |
I use 3 on mine and A4 Card stock for paper. No problems here. I do use my own carrier sheets though. (plastic covers for project work) |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|