Yes.
I'm about to just order a new $30 blade assembly and be done with it, I have cutting to do.
| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| New Blade == No Cut http://www.worldworksgames.com/forum/viewtopic.php?f=62&t=7553 |
Page 1 of 1 |
| Author: | loydb [ 09-01-2009, 07:38 AM ] |
| Post subject: | New Blade == No Cut |
| Author: | Highland_Piper [ 09-01-2009, 10:19 AM ] |
| Post subject: | |
I've had mine for close to two years now and I've yet to need to change the blade. Sorry I don't have any suggestions. |
|
| Author: | MelEbbles [ 09-01-2009, 01:13 PM ] |
| Post subject: | |
The biggest culprit for that is not having the cap screwed in all the way or screwed on a little askew. Remove the cap and thread it back on. If it still doesn't cut, take a photo of the blade unit for me: 1. I want a shot of the top of the blade unit (the hole end) 2. I want a shot of the front, with and without cap installed The purpose of the photos is so I can tell if there's an obvious defect on the unit itself. -Mel |
|
| Author: | loydb [ 09-01-2009, 01:48 PM ] |
| Post subject: | |
I'm sure that I'm not crossthreaded, and the cap is down as tightly as I can get it. |
|
| Author: | MelEbbles [ 09-01-2009, 02:11 PM ] |
| Post subject: | |
| Author: | loydb [ 09-01-2009, 02:38 PM ] |
| Post subject: | |
| Author: | MelEbbles [ 09-01-2009, 04:47 PM ] |
| Post subject: | |
| Author: | loydb [ 09-02-2009, 01:41 AM ] |
| Post subject: | |
Yes. I'm about to just order a new $30 blade assembly and be done with it, I have cutting to do.
|
|
| Author: | MelEbbles [ 09-02-2009, 03:21 AM ] |
| Post subject: | |
| Author: | loydb [ 09-02-2009, 03:37 AM ] |
| Post subject: | |
| Author: | MelEbbles [ 09-02-2009, 03:42 AM ] |
| Post subject: | |
| Author: | loydb [ 09-02-2009, 05:24 AM ] |
| Post subject: | |
| Author: | MelEbbles [ 09-02-2009, 01:25 PM ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|