| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| Robo Cutter CC200-20 woes http://www.worldworksgames.com/forum/viewtopic.php?f=62&t=7887 |
Page 1 of 1 |
| Author: | bengkohn [ 12-06-2009, 07:00 PM ] |
| Post subject: | Robo Cutter CC200-20 woes |
| Author: | Highland_Piper [ 12-06-2009, 10:31 PM ] |
| Post subject: | |
| Author: | bengkohn [ 12-07-2009, 04:10 AM ] |
| Post subject: | |
I believe I have the N American model. I live in the USA and bought it from a store in the USA. I'm more concerned about it cutting the page out wrong than the registration. Now that I've gotten it to register once, I'm assuming I can eventually get it to do it again, but if it cuts out the pages wrong, I'm sunk. Thanks in advance. |
|
| Author: | bengkohn [ 12-07-2009, 02:26 PM ] |
| Post subject: | |
| Author: | Highland_Piper [ 12-07-2009, 02:59 PM ] |
| Post subject: | |
| Author: | bengkohn [ 12-07-2009, 05:14 PM ] |
| Post subject: | |
I chose another sheet from the streets set (4 posts) and it worked fine. I'm wondering if the stairs sheet has lines too close to the registration mark, and I just picked a bad one to start testing on. Except for the stairs sheet, I can get them to work now. Just like me to start on the one I can't get to work. I've had one more problem sheet as well, but it registered, so I can retest that one tomorrow. |
|
| Author: | Highland_Piper [ 12-07-2009, 10:53 PM ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|