I'm knee deep in building Thoumont TLX bits, though it's going much faster than my dwarven dungeon or garden stuff thanks to my new cutter. Thank you guys for (a) making really nice quality stuff, and (b) making it cutter compatible!

I wanted to point out a couple things I ran into while doing the Thoumont's build.

Thoumont's GSD file truss_6inch_1way.GSD is missing several score lines. floors_6inch_diagonal_down.GSD lacks the cut lines on the flap where the linx tab goes. Thoumont_Stairs_2.gsd doesn't have score lines on the little flaps on the last step.


Oh, and not exactly Automated Cutting Support related, but generic_instructions.pdf has a number of typos and formatting errors in it:

I notice in the pdf you refer to the system as "TerrainlinX" or "Terrainlinx" but on the printed material, it's "TerrainLinX".

p3: "Somehting which crashes..."
p3: the indentation of "COMPACT STORAGE!" bullet is different than others.
p13: it sure looks like "roof panels" is written "roofpanels"
p13: "terraces and the iikes"
p14: "Ther is one exception"
p14: "one with little flaps" - one should be capitalized.
p14: "stability for you roof"
p14: "Thes can only be positioned..."
p14: "creting a small gap"
p15: it sure looks like last use of "roof panel" is written "roofpanel"

I'll admit I haven't really read the stuff past Methods & Materials...


I can't wait for cliffs and the pathfinder dungeon set to come out!