Has anyone else noticed that the Big floor from the Titan Command GSD file seems off?

The GSD file is the same as the others, but the Floors are at a different place on the page. I have printed it off a few different times and it is always off... so the cut files don't work for it...

Strange...I have used that file a lot, and didn't notice any problems...I shall recheck it and see whats up.

Yea, I have the same problem!

It looks like the Titan Control print PDF is offset compared to the Titan Codename, but the cut file has the cuts in the same location.

edit:
(When I say offset, I mean that the floor tile prints in a slightly different location from the registration marks compared to the other Titan set.)

It could possibly be limited to certain tiles, as I didn't check them all.

The only thing i can think of is one is centered when printed and the other not, but I have never changed my print settings...

So maybe the base file is different (ie one is precentered or something)