WorldWorksGames http://www.worldworksgames.com/forum/ |
|
Craft cutter newb question. http://www.worldworksgames.com/forum/viewtopic.php?f=65&t=11452 |
Page 1 of 1 |
Author: | Frost [ 06-22-2012, 07:42 AM ] |
Post subject: | Craft cutter newb question. |
Do all terrainlinx products include support for craft cutters? Also, I've decided to take the plunge and invest in one. What are the most recommended cutters? |
Author: | mproteau [ 06-22-2012, 07:54 AM ] |
Post subject: | Re: Craft cutter newb question. |
Check out this forum: Specifically, for knowing what to buy. To answer your specific questions, there are older sets that do not support cutfiles, but anything in the TerrainLinx and SwiftScenics line should be supported. I'm pretty sure *most* things if not all things located under the heading "Classics" and "The Vault" do not have cutfile support, though if you're skilled enough with manipulating images, and using the cutter's software, you can make cutfiles for many of the older pieces. |
Author: | Talae [ 06-22-2012, 08:18 AM ] |
Post subject: | Re: Craft cutter newb question. |
Congratulations on the decision. I love my Craft Robo and have used it tons since I got it during these past holidays. mproteau has it right. Everything in the TerrainLinx and SwiftScenics lines has cutter support. The Older stuff does not, but in theory could if someone were to submit a full kitbash to WWG. |
Author: | mproteau [ 06-22-2012, 08:33 AM ] |
Post subject: | Re: Craft cutter newb question. |
Author: | Talae [ 06-22-2012, 08:50 AM ] |
Post subject: | Re: Craft cutter newb question. |
Author: | mproteau [ 06-22-2012, 08:53 AM ] |
Post subject: | Re: Craft cutter newb question. |
Page 1 of 1 | All times are UTC - 8 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |