Streets of Blood
Page 1 of 1

Author:  daemonkin [ 07-26-2012, 04:33 PM ]
Post subject:  Streets of Blood

Hi guys,

I have been using the Himmelveil PDF documents to print out a basic floorplan for my games of Malifaux. I have been printing out onto A4 label paper (1 label per sheet ) and then sticking down 4 print outs per 1 foot square of cork tile.

This has worked very well and I have done the same with the Streets of Blood set. Next up I would like to try and do buildings but I am planning on using foam core / foamboard to stick the labels onto before I cut out.

A little jiggery pokery with Photoshop will help me get the most out of each label sheet.

I am just curious as to any potential pitfalls I may fall into if anyone has tried something similar before or am I going blind?

Thanks in advance for any tips


Author:  Brainscan [ 09-13-2012, 02:46 AM ]
Post subject:  Re: Streets of Blood

I suppose the only issue is lack of variation for modularity. Im planning a similar approach myself. I would like to see your attempts. Do you have any photos?

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group