Alright thanks, so counting the gray tabs it is 3 inches then, and the height is right then so all is actually good.
thanks again!
| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| codename titan dimensions/print issues http://www.worldworksgames.com/forum/viewtopic.php?f=65&t=12940 |
Page 1 of 1 |
| Author: | criddopher [ 11-05-2015, 08:40 AM ] |
| Post subject: | codename titan dimensions/print issues |
Hey, Im new here. I just downloaded the titan pack and I'm trying to print out the walls. I think my scaling is off.. When i print 3" walls they end up 1.5" tall and 2.5" long. How tall are the walls supposed to be? Im using an hp envy 4500. 110lb cardstock. Ive tried setting actual size on the printer, and also selecting boarderless. I dont see any options saying anything about page scaling.. Ive tried using sumatra pdf and adobe reader.. Im out of ideas here.. Anyone around that can help me out? thanks |
|
| Author: | Ninevah [ 11-05-2015, 11:13 AM ] |
| Post subject: | Re: codename titan dimensions/print issues |
The scaling warning that you've probably seen is for the settings in Adobe Reader. It's in the print menu. Here's a screenshot: The 3" length should be from edge to edge, including the gray tabs that slot into the posts. Mine measure out to be just shy of 3". They should be 2" tall after they're folded and glued, but that should be straightforward. |
|
| Author: | criddopher [ 11-05-2015, 07:46 PM ] |
| Post subject: | Re: codename titan dimensions/print issues |
Alright thanks, so counting the gray tabs it is 3 inches then, and the height is right then so all is actually good. thanks again! |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|