Can you send these Pres-a-Ply label sheets through the Craft Robo? Hmm, after thinking about it, do you want to cut out the mounts before securing them to foamcore? I have a feeling no.
| WorldWorksGames http://www.worldworksgames.com/forum/ |
|
| Starter TLX questions http://www.worldworksgames.com/forum/viewtopic.php?f=65&t=7793 |
Page 1 of 1 |
| Author: | Thraug [ 11-05-2009, 06:06 PM ] |
| Post subject: | Starter TLX questions |
| Author: | Halcy [ 11-05-2009, 06:18 PM ] |
| Post subject: | |
| Author: | CapnG [ 11-05-2009, 09:05 PM ] |
| Post subject: | |
| Author: | vejlin [ 11-05-2009, 11:48 PM ] |
| Post subject: | |
| Author: | Thraug [ 11-06-2009, 07:51 AM ] |
| Post subject: | |
| Author: | wejarvis4 [ 11-06-2009, 07:55 AM ] |
| Post subject: | |
| Author: | Gamesmith Denny [ 11-06-2009, 08:57 AM ] |
| Post subject: | |
| Author: | Thraug [ 11-06-2009, 11:56 AM ] |
| Post subject: | |
Can you send these Pres-a-Ply label sheets through the Craft Robo? Hmm, after thinking about it, do you want to cut out the mounts before securing them to foamcore? I have a feeling no.
|
|
| Author: | wejarvis4 [ 11-06-2009, 12:02 PM ] |
| Post subject: | |
Ya you're really doing the "fine detail cutting" with the razor, while you cut the foam board. you can quickly rough cut them with scissors. |
|
| Author: | akanon [ 11-06-2009, 01:17 PM ] |
| Post subject: | |
I've had great results with using a stencil and a can of spray paint. My attempts to otherwise alter the process didn't turn out so well, but I don't think you can beat the speed or cost-per-mount. I can probably send you the GSD I put together for the stencil. I spray some temporary adhesive on once side, lightly burnish, then fire a few quick bursts of spraypaint. I imagine that a card stock stencil would last for at least 10 uses before it got too saturated with paint. |
|
| Author: | wejarvis4 [ 11-06-2009, 01:51 PM ] |
| Post subject: | |
| Author: | Thraug [ 11-11-2009, 07:40 AM ] |
| Post subject: | |
Do you guys remove the template after cutting the foamcore? Or, do you leave the template on the fomacore and just let the tile texture sheet cover up the template? Is there any functional reason to remove the template from the foamcore after cutting the foamcore? Does it impact the functionality of the LinX tabs in any way? Thank you! |
|
| Author: | Kane [ 11-11-2009, 08:08 AM ] |
| Post subject: | |
I would just leave the template. Thats what I did and it has not hurt anything. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|