Ok, this is probably obvious to everyone else but I wanted to clear up a question I have been having.

On the Floor tiles, the sides of the tiles have the little flaps that cover the LinX entry points for the tiles. On the underside of the tiles there is a little oddly shaped quadrilateral area that attaches to the flaps on the side.

Are we supposed to CUT off the quadrilateral area from the sides OR is that area somehow supposed to stay attached and tuck into the slots that the flaps are covering.

I've been cutting them off, but that's not what it shows on any of the tiles... There are no green or solid black lines on the bottom of the flaps, so it almost looks like we are supposed to leave those white parts attached and then tuck them into the slots some how.

Am I missing something or are the markings on the floor tiles misleading....

Thanks for the help all,
Mark

If your talking about the bottom of the tile (now it is morning and I am feeling very thick) then yes you are to cut that section out. It allows you to retrieve the flap and I'm sure there was another reason but I've only had one cup of coffee this mornings so far.