Ok, here's a (almost) full Malifaux board, 2'x3'. I actually realised that there's not much point spending time to build in the 6" of the standard deployment zone as models are out of there in no time, so instead I built the middle band (since I'll place the TCP on a green grass board I'll just add some trees in each deployment zones and bob's your uncle!).
I used the 3 sets and had still some spare bits (in each set, and I think I could have done one more small house if needed) so I come back on what I said earlier of the need of buying more sets, what I have is fine for a 3'x2'!
In terms of clips I was left with 7 L clips and didn't have to force myself to save them other than the scattering recommended, so another great result!
I feel happy that I managed to do a full board! It's not overly complicated and although took me 2 days to make, would probably take about 30min if following the pics I took.
I hope it helps others for lay-out ideas!
Oh and lastely I want to point out that although the clips seem very obvious when looking at the pictures I think it's primarily due to the flash as when you look at the table with naked eye they don't pop out like this.
Great great product!!
Final shot, sniper in position...
