WorldWorksGames
http://www.worldworksgames.com/forum/

"Capper" clips
http://www.worldworksgames.com/forum/viewtopic.php?f=69&t=10282
Page 1 of 1

Author:  Magius [ 09-06-2011, 11:37 AM ]
Post subject:  "Capper" clips

Something that I would love to see with this system, and something that I think is needed, is a 'capper' clip, or a single-point clip that attaches to the edge of a tile, allowing it to rest on top of a wall without having it attached to the next tile or requiring a bit of clip to stick off the edge.
This would be useful in the following cases:

You have a section of roof designed to fit perfectly over the room beneath that you don't want to attach to another piece on the board, and which has nothing to support it in the center

You have a piece at the edge of the board that you don't want to attach a railing or wall to

For props, you want a wider base without pulling out an L or T clip.

At a minimum, I'd say these should be sold in packs of 24 (enough to cover all the edges on a 3' x 3' board with no walls along the edges), and would be a definite purchase for me.
Magius out.

Author:  Gamesmith Denny [ 09-06-2011, 12:33 PM ]
Post subject: 

Interesting idea. Will definitely keep that in mind while developing future bits.

Author:  Riley [ 09-06-2011, 01:55 PM ]
Post subject: 

Seconded. They would also be useful for stacking hollow storefront buildings.

Author:  beepeearr [ 09-11-2011, 05:58 PM ]
Post subject: 

Thirded, I could definitely see a couple of different uses for these.

Author:  Noshrok Grimskull [ 09-12-2011, 01:42 AM ]
Post subject: 

Fourthed? Forded?
Whatever, I'm all for it, too! :D

Author:  Mononofu [ 09-12-2011, 04:26 AM ]
Post subject: 

Fnorded.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/