What is the maximum amount of foamcore that can be used to make the Lost Halls of the Dwarven Kings dungeon? How can it be made as sturdy as possible, and what thickness foamcore would be best? What color foamcore? What thickness card stock? What type of glue? Is this dungeon available already printed on card stock? I don't have a color printer.

Thanks a lot.

I used to use a brothers printer with generic ink cartidges. A full set of 4 cartridges only cost $20. Now the ink wasn't color fast, but thats no problem as long as no one drinks by it.

Can foamcore be used for the walls of this build as well? If so, would you still use the same 1/4" (or 3/16") thickness foamcore?

Because of theway the TLX system works it would be difficult to use foamcore for the walls. The ends of the walls have what ammount to deep hooks that fit into slots on the pillars - foamcore would be thicker than the slots, and would throw the whole thing off.

You might be able to have the hooks only on one side of the wall, but it would still be off centered. (Side, not end, just to be a shade more clear.)

The Auld Grump

O.k., I've finally uploaded some pics...



The 8 level tall tower sits on 2 levels of sewer.

More photos here: [/url]

Very impressive. Great pics!

It's... BIG.