Hello! First post!

I purchased the Village Works and the models look really cool. So far I've put together one building and noticed that it's a bit small for my needs.

I'm planning on using it for a Warmachine board and I've noticed that there are plenty of others that are doing the same thing.

I figure if I upscale the printing by 15-20% it should do the trick.

Here's my problem...

When I upscale the output it doesn't recenter on my printer (Epson 300). So the borders are upscaled as well and the bottom and right side of the models are cut off.

This happens pretty much at everything down to around 10%.

Any suggestions?

Thanks!

=Shreak

What Aleph said is pretty much the truth, although some versions of Acrobat let you actually crop the pages, so you could crop the borders and such off the page, then scale up and print. Note: If you do this, make a copy of the file first and do all edits on the coyp.