Hey all,
I am trying to build my first tower. Yeah, for me!! Well I did the base tile. and then printed the lower walls. Followed the direction in the instructions. My problem seems to be that the tower, when all glued together is to large for the base tile. On two sides there is a little bit that hangs over the edge.

I have the scaling option disabled on my printer. I am stumped. any suggestions? I intend to print and cut it out again.

Keith

I also noticed I had to be careful as I was gluing the base to the tower or at least the first one as it looked like it was not going to fit. As I built more and more bases, I went a little quicker each time as I got more practice.

Just take your time with it and go at a slow pace. You might also try 'dry' fitting the completed section to the base to make sure it will fit correctly.

Skunk

Check out my fantasy campaign, Wizard Quest, a world using Wizards of the Coast’s 3.5 DnD system by visiting .

Check out the NEW IMPROVED flash teaser for my sci-fi campaign, , coming Jan 2007. I’ll be using D20 Future for the rules.

Check out what games I’m working on and their status by visiting .

Tampa Bay Game Players Forum is now available, .

If you're still having issues, you might even try scoring your fold lines a tiny bit over to one side, to compensate for the overhang. Your edging will cover up any noticeable texture differences.