Hi all;

First time builder and poster
Some newbie questions

What is the scale of the models? I.E. 1 inch=?? feet

Where is the "Interactive GUI" indiscated on the CWU page

Why aren't the sides of the octagon towers all the same dimensions?
4 sides are 1 1/2 inches and 4 sides are 2 1/8 inches

Thanks
Paul

Welcome to the forum Lancealittle. To answer part of your question the "interacitive GUI" was originally part of the physical version (CDRom retail version) of CastleWorks Ultimate. Basically all it did was launch the CDRom version and break everything down into categories on a single interactive pop-up screen. This was removed for the pure PDF version to bring down the total file size.

I copied the promotional text over and forgot to remove that bit of text. Sorry for the confusion.

Since this is a topic for CWU questions I figured it would be better to ask here than to start a whole new topic.

Can someone give me the height of a CWU fortification wall with and without the crenelation, I need exact heights as this is for the SiegeTower modification I am doing and even though I have two siege towers printed out I may need to wait until I can print two more as I will already be doubling the base size, I may need to double the height size (horrifyingly possibly even triple), this hinges on the answer. Normally I'd have the wall printed but atm I have no ink and aside from buildings, and the gatehouse I don't have any of the walls and towers printed out (though I plan on making this tower able to be modified to different heights much like the towers from CWU).

Edit: I need the measurement from the base of the wall to the top, not including the ground tile the wall is set upon.