Hello,

I'm a newbie here, so please excuse my question, I am sure it has been answered before.

I bought Shellendrak Manor, are planning my model, but couldn't find out how to use a second floor. How can I use both floors for my battles and be able to put them back together?

Do you have some good ideas? I thought about paper clips or maybe something like paperlinx!?

Thx for any help!

Daniel

In the instructions for exterior walls, there is mention of tabs that cover the foam core of the second floor and help as a guide or connector for the second floor if it is put on hanging below the other a bit. I just bought it myself and have to go through a bit more as well, but take a closer look at that Exterior Walls instructions set and I think you will find what I was talking about.

Hello savage.daniel and welcome to the boards!

As thomaso827 mentioned there are small coloured strips below each exterior wall section. When you put your second floor together, you glue these to the bottoms of the wall, allowing you to hide the foamcore and create a "lip" for your model at the same time. If you build the Grand Gallery, the staircase railings will also serve as an internal alignment aid.

Have fun and thanks for supporting WorlWorks Games!

Also, the Harbormaster House has some external brace pieces that can be glued to the corners, and I think you could print out an extra external wall section to cut into these pieces - fold and glue to the outside corners of the first floor if you dont want anything extending below the second floor. I think if you cut out a 1" square, fold it in half, then glue half to the top of each corner, the colors should blend enough to hide them. Just a thought since I havent gotten any where near that far yet...